Views: 0 Author: Site Editor Publish Time: 2024-05-31 Origin: Site
The mixing unit consists of a high-speed mixer and a horizontal cooling mixer. The high-speed mixer has three stirring blades and a deflector. Under the action of the material, the material rotates at a high speed and turns from the inside to the outside, from the outside to the top, and from the top to the inside, so that the material generates heat due to self-friction, and the temperature rises rapidly. Material mixing process requirements. Then it enters the cooling mixer through the discharge mixer. After cooling, the three sets of stirring blades run at low speed, and the water flow in the interlayer of the cold pot body is forced to cool down, so that the material can be cooled rapidly to meet the production process requirements.
Common faults and solutions of PVC mixer:
Q1: Hot mixing over time?
Troubleshooting1: Trackslip of transmission belts.
Solution: Adjust the belts to proper tension.
Troubleshooting2: Serious wear-out of mixer blades.
Solution: Replace with new mixer blades.
Troubleshooting3: Thermocouple was not inserted at position or residuals on thermocouple.
Solution: Take out thermocouple and clean out and install at right position.
Q2: Cooling mixing over time?
Troubleshooting1: Trackslip of transmission belts.
Solution: Adjust the belts to proper tension.
Troubleshooting2: Cooling water circulation closed or temperature of cooling water is high.
Solution: Check&adjust the water pump or chiller.
Troubleshooting3: Transmission fault of thermocouple.
Solution: Replace with new thermocouple.
Q3: The discharge mixer can not be fully closed or can not be opened.
Troubleshooting1: Low pressure of compressed air
Solution: Check compressed air pipelines and compressor
Troubleshooting2: Non-operation of solenoid mixer
Solution: Check the wiring and cables for solenoid mixer, replace with new one if needed.
Troubleshooting3: Piston sealing of cylinder was broken.
Solution: Replace with new sealing.
Troubleshooting4: Residuals blocked the front edge of discharge mixer.
Solution: Clean out the residuals.
Q4: Powders leaked from the hot/cold mixer lid?
Troubleshooting1: Rubber sealing of lid was broken.
Solution: Replace with new rubber sealing.
Troubleshooting2: Lid was not tightened
Solution: Clean out the matching surface of lid and mixer bowl and tighten the lid.
Q5: Powders leaked from jet nozzle of cooling mixer?
Troubleshooting1: Interior sealing of shaft sleeve was broken.
Solution: Replace with new sealing.
Troubleshooting2: Bag filter was sticky with caking, air flow not pass through.
Solution: Wash the bag filter or replace with new one.
Q6: Noise from bottom of mixer bowl?
Troubleshooting1: Check mixer blades if loosen.
Solution: Tighten the nuts of mixer blades.
Troubleshooting2: Foreign material went inside the mixer bowl.
Solution: Stop the mixer and clean out.
Troubleshooting3: Sealing of main shaft bearing was broken and contaminated with powders
Solution: Replace with new sealing.
Troubleshooting4: Main shaft bearing lack of lubrication grease.
Solution: Check the grease pipeline and pump, ensure the sufficient grease for bearing.
Troubleshooting5: Main shaft bearing was broken.
Solution: Replace with new bearing.
Precautions:
1. The unit does not allow load start and frequent start. It should run normally before feeding, and should not stop when discharging.
2. It is not allowed to use the lifting device when the lid is pressed to prevent the lid from being deformed and damaged.
3. The pressure of cooling water in the mixer should be strictly controlled within the range of technical parameters to prevent deformation or water leakage, and the pressure should be less than or equal to 0.2MPa